Konwledge Center >> Now Location: Using and maintenance of crushers
Using and maintenance of stone crushers
- Key points of using and maintenance of crushers can be classified as follows according to different machine types and working conditions:
1. Before start, driving wheel should be moved for one or two circles artificially and starts to work after confirmation of stable movement. Feeding should be implemented after regular operation.
2. Before stop of power, vibration feeder should be stoped firstly and materials in it should be cleaned up.
3. Tempreture of draft should be attached great importance during operation, and perfect lubrication should be guaranteed and notice whether there is abnormal sounds and vibration. While irregular situations occur, stop should be implemented to see whether there are materials not easy to crush, and stop the motor power.
4. Even feeding should be guaranteed to avoid overload. Equipment should be strictly protected from metal, wood and other un-easy crush materials. If crushing can't be implemented, moisture should not be too high; during wet-type crushing, proper moisture should be kept so as to avoid inadequaty of moisture or reduce capacity.
5. Examine wherther size of grains can meet relative requirements. If propotion of over-big grains is too high, reasons should be figured out(such as over-big clearance between grate bars, over-wide discharge opening, wearance of hammers and so on ), and measures should be carried out accordingly.
6. While crushers are stopped, fasterning bolt should be examined to see whether they are tight enough as well as wearness of wearable parts. For crushers, woods among teeth should be picked out during stop time.
7. Weared parts should be changed or repaired in time.
8. Securing device of crushers should always work in a good condition to avoid invalidity caused by negligence. - In the cement grinding plant, crusher machines are used to crush limestones, gypsum, coal and other cement raw materials into small particle sizes for further grinding.
Jaw crusher in cement production line: Jaw crusher is the coarse crusher machine. it is used to crush limestones in the cement grinding plantl. Limestone powder is the raw material for makeing cement. So. limestone is firstly crushed into small particle size, then grinded into powder.
Impact crusher in cement grinding plant: Impact crusher is usually used in secondary crushing process. So, in the cement production line, impact crusher is used in limestone crushing plant. It can crush limestone into powder.
Cone crusher used in cement plant: Cone crusher is the most common fine crushing machine. In cement grinding plant, cone crusher is mainly used in limestone crushing unit, gypsum crushing unit and coal crushing unit.
Hammer crusher in cement production line: In cement production line, hammer crusher is used to crush coal, gypsum into powder. - Crusher and Mill PDF Free Download
Copyright @ Shanghai Shibang Machiery Co.,Ltd - Version 2010 Crusher